Rat IL1RN ELISA Kit, Lot 21AO-1281 [Cancer Immune Checkpoint Assay Kit] (CAT#: IOK-05-P1192)

Pre-coated, ready to use 96-well strip plate
Plate sealer for 96 wells
Standard
Sample/Standard Dilution Buffer
Biotin-labeled Antibody (Concentrated)
Antibody Dilution Buffer
HRP-Streptavidin Conjugate (SABC)
SABC Dilution Buffer
TMB Substrate
Stop Solution
Wash Buffer (25 x concentrate)
Instruction manual

46.88 pg/mL

100 μL

3.5 h

Pre-coated

1.Bring all reagents to room temperature (18-25 °C) before use.
2.Wash Buffer: Dilute 30 mL of Concentrated Wash Buffer with 720 mL of deionized or distilled water to prepare 750 mL of Wash Buffer.
3.Standard working solution: Add 1.0 mL of Reference Standard &Sample Diluent, let it stand for 10 min and invert it gently several times. After it dissolves fully, mix it thoroughly with a pipette. This reconstitution produces a working solution of 200pg/mL.
4.Biotinylated Detection Ab working solution: Centrifuge the Concentrated Biotinylated Detection Ab at 800xg for 1 min, then dilute the 100x Concentrated Biotinylated Detection Ab to 1x working solution with Biotinylated Detection Ab Diluent.
5.HRP Conjugate working solution: Calculate the required amount before the experiment.

Intra-assay Precision (Precision within an assay): 3 samples with low, mid range and high level Rat IL-1ra/IL-1F3 were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, mid range and high level Rat IL-1ra/IL-1F3 were tested on 3 different plates, 20 replicates in each plate.
Both intra-CV and inter-CV are < 10 %.

4 °C,-20 °C

6 months

For Research Use only

Interleukin 1 Receptor Antagonist (IL1RA)

DIRA; ICIL-1RA; IL-1RN; IL-1ra; IL-1ra3; IL1F3; IL1RA; IRAP; MVCD4; IRAP1; IL1RN; IL-1RA; F630041P17Rik; interleukin 1 receptor antagonist; interleukin 1 receptor antagonist-like; IL1RN; Il1rn; IL1RNL

IL1RN, DIRA, ICIL-1RA, IL-1RN, IL-1RA, IL-1ra3, IL1F3, IL1RA, IRAP, MVCD4

60582

P25086

NF-kappaB Signaling, Hormone Transport, Cancer Immune Checkpoints

1.Add 100 μL standard or sample to each well. Incubate for 90 min at 37 °C.
2.Remove the liquid. Add 100 μL Biotinylated Detection Ab. Incubate for 1 hour at 37 °C.
3.Aspirate and wash 3 times.
4.Add 100 μL HRP Conjugate. Incubate for 30 min at 37 °C.
5.Aspirate and wash 5 times.
6.Add 90 μL Substrate Reagent. Incubate for 15 min at 37 °C.
7.Add 50 μL Stop Solution. Read at 450 nm immediately.